Reference | 6
29
6 Reference
6.1 Attaching an Optional Monitor Arm
An optional arm (or optional stand) can be attached by removing the stand section. Please
refer to our web site for information on monitor arms (or stands) that are supported.
(
When attaching an arm or stand, the installable orientations and movement range (tilt angle)
are as follows:
• Orientation
• Movement range (tilt angle)
Down: 45˚
Up: 45˚
Attention
• When attaching an arm or stand, follow the instructions of the respective User’s Manual.
• When using another manufacturer's arm or stand, confirm the following in advance and select
one conforming to the VESA standard.
– Clearance between screw holes: 75 mm x 75 mm 100 mm x 100 mm
– Plate thickness: 2.6 mm
– Strong enough to support weight of the monitor unit (excluding the stand) and attachments
such as cables
• Connect the cables after attaching an arm or stand.
• The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment
damage.
• Check periodically that the screws are tight enough. If the screws are not tight enough, the
monitor may come unattached. This may be the cause of injury or damage.
1.
Lay the LCD monitor on a soft cloth spread over a stable and flat surface with the
LCD panel surface facing down.
2. Remove the stand.
Prepare a screwdriver.
Use the screwdriver to loosen the screws that secure the unit to the stand.
