eisenblatter Varilex Polisher Akku, Original Instructions Manual

Page: 25 / 28

www.eisenblaetter.de
25
Original instructions VARILEX
®
POLISHER HT / VARILEX
®
POLISHER AKKU
EN
12. Troubleshooting
12.1 Mains powered machines:
The electronic signal indicator (A2-1) lights up
and the load speed decreases.
There is too
much load on the machine! Run the machine in
idling until the electronic signal indicator switches off.
The machine does not start. The electronic
signal indicator (A2-1) flashes.
The restart
protection is active. If the mains plug is inserted
with the machine switched on or if the power supply is
restored following an interruption, the machine does not
start up. Switch the machine off and back on again.
12.2 Cordless machines:
•
The electronic signal indicator (B1-2) lights up
and the load speed decreases. The temperature
is too high! Run the machine in idling until the
electronic signal indicator switches off.
•
The electronic signal display (B1-2) flashes and
the machine does not start. The restart protection is
active. The machine will not start if the battery pack is
inserted while the machine is on. Switch the machine
off and back on again.
13. Maintenance
Disconnect the mains plug or remove the battery pack
from the machine before starting any maintenance work.
It is possible that particles deposit inside the power tool
during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective
insulation of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a
vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from the
power source and wear protective goggles and a dust
mask.
14. Repairs
Repairs to power tools must only be carried out by
qualified electricians!
If the connection lead is damaged, it must be replaced
by a special connection lead.
Contact your sales agency or Eisenblätter if you have
Eisenblätter power tools requiring repairs:
Gerd Eisenblätter GmbH
Jeschkenstraße 12d
82538 Geretsried
info@eisenblaetter.de
www.eisenblaetter.de
15. Environmental protection
The generated sanding dust may contain harmful
substances: dispose of appropriately.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
tools, packaging and accessories.
Only for EU countries: never dispose of power
tools in your household waste! In accordance
with European Directive 2002/96/EC relating
to electrical and electronic waste and implementation of
national law, used electrical tools must be collected
separately and disposed of in an environmentally friendly
manner at recycling centres.
Special notes regarding cordless machines:
Battery packs may not be disposed of with regular waste.
Return faulty or used battery packs to your sales agency.
Do not allow battery packs to come into contact with
water!
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting (e.g.
by protecting them with adhesive tape).