GB
9
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety information.
1. Safety Information
Please refer to the booklet included in delivery for the
safety information.
CAUTION
Read all the safety information and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout
2.1 Drag, crosscut and miter saw (Fig. 1-3)
1. Handle
2. ON/OFF
switch
3. Release
lever
4. Machine
head
5. Saw shaft lock
6. Movable blade guard
7. Saw
blade
8. Vertical clamping device
9. Roll base with limit stop
10. Holding bar for the roll base
11. Stop rail
12. Table insert with cutting depth scale
13. Latched position lever
14. Locking grip
15. Pointer
16. Scale
17. Turntable
18. Fixed saw table
19. Scale
20. Pointer
21. Horizontal clamping device
22. Locking screw
23. Chip box
24. Drag guide
25. Locking screw for drag guide
26. Guard
27. Fastening bolt
28. Locking screw for the horizontal clamping device
29. Locking screw for the vertical clamping device
30. Locking screw for the roll base
31. Foot with rubber stopper
32. Foot
33. Extractor adapter
34. Knurled screw for cutting depth limiter
35. Stop for cutting depth limiter
3. Items supplied (Fig. 1, 4)
Drag, crosscut and miter Saw
Clamping device (8)
Roll base with limit stop (9)
2 x Holding bar for the roll base (10)
Chip box (23)
Allen key (A)
Allen key (B)
4. Intended use
The universal saw is designed for cross-cutting wood
and plastic. In accordance with the operating
instructions the equipment can also be used to saw
hollow metal profiles with a rectangular cross-section.
Sawing metal profiles may only be carried out with
crosscuts. The equipment is expressly not permitted
to saw metal with a tensile strength of more than 400
N/mm², hardened metal, combustible and reactive
metals (such as magnesium and magnesium alloys),
all kinds of round materials and firewood.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse.
The user / operator and not the manufacturer will be
liable for any damage or injuries of any kind caused
as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
The equipment is to be operated only with suitable
saw blades. It is prohibited to use any type of cutting-
off wheel.
To use the equipment properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
Anleitung_RT_XM_305_SPK7:_ 22.06.2010 15:46 Uhr Seite 9
