GB
- 17 -
Operating the
fl
ow switch:
The operating mode is indicated by the LEDs.
Yellow Power ON is lit:
The power cable is connected.
Yellow Power ON and Green Pump ON are lit:
The pump is in operation and starts up immedia-
tely; a consumer for drawing o
ff
medium is open.
Yellow Power ON, Green Pump ON and Red
Failure are lit:
The pump is running dry without any medium. For
approx. 30 seconds the pump will try to restore
the
fl
ow.
Yellow Power ON and Red Failure are lit:
After approx. seconds without any
fl
ow the motor
will switch o
ff
.
The dry running guard has tripped; it is no longer
possible to draw in the medium. Use the pump’s
operating manual to
fi
nd the cause of the fault
(e.g. a leaking intake line) and rectify it. Then re-
start the pump by pressing the ON button (5) on
the
fl
ow switch.
Yellow Power ON is blinking:
The pump is building up pressure (e.g. a water
tap is closed) and then switches o
ff
automatically.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
The equipment is almost completely maintenance
free. In order to ensure a long service life, howe-
ver, we recommend that you regularly check and
care for the product.
Danger!
The equipment must be disconnected from the
power supply (pull the power plug) prior to perfor-
ming any maintenance.
8.1 Servicing
•
If the equipment becomes clogged, connect
the discharge line to the water line and dis-
connect the suction hose. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clog-related problems.
•
There are no parts inside the equipment
which require additional maintenance.
8.2 Cleaning the coarse
fi
lter insert (Fig. 3-4)
•
Clean the coarse filter insert at regular inter-
vals, and replace it if necessary.
•
Remove the coarse filter screw and coarse
filter together with the non-return valve.
•
Do not use abrasive cleaning agents or petrol
to clean the coarse filter and the non-return
valve.
•
Clean the coarse filter and the non-return val-
ve by tapping them on a flat surface. In cases
of stubborn dirt, first clean with soapy water,
then rinse with clear water and air-dry.
•
Assemble in reverse order.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Anl_GC_AW_6333_SPK7.indb 17
Anl_GC_AW_6333_SPK7.indb 17
28.09.15 11:23
28.09.15 11:23
