GB
11
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Drill
chuck
2. Drill depth stop
3. Drill/hammer drill selector switch
4. Locking
button
5. ON/OFF
switch
6. Speed
controller
7. Clockwise/Counter-clockwise
switch
8. Additional
handle
3. Proper use
The drill is designed for drilling holes into wood, iron,
non-ferrous metals and rock using the appropriate
bits.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage:
230 V ~ 50 Hz
Power input:
650 W
Idling speed:
0-2,600 min
-1
Drilling capacity
Concrete 13 mm
Steel 10 mm
Wood 25 mm
Protection class:
II /
쓑
Weight:
1.8 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level
93.2 dB(A)
K
pA
uncertainty 3
dB
L
WA
sound power level
104.2 dB(A)
K
WA
uncertainty 3
dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Hammer drilling in concrete
Vibration emission value a
h
= 19.667 m/s
2
K uncertainty = 1.5 m/s
2
Drilling in metal
Vibration emission value a
h
= 4.143 m/s
2
K uncertainty = 1.5 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Anleitung BT-ID 650 E_SPK1:_ 20.02.2008 11:09 Uhr Seite 11
