15
GB
6.5 Speed control (Fig. 1a, BG-EL 2501 E only)
The device is fitted with an electronic speed
controller. To use it, turn the speed controller (Fig. 1a/
Item 11) to the desired position. Use the device only
with the speed which is actually required and do not
let it run at a speed which is faster than necessary.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
After shaking out the debris bag, turn it inside out
and thoroughly clean it in order to prevent mould
and unpleasant odors from forming.
You can use soap and water to clean out a
heavily soiled debris bag.
Rub a bar of dry soap across the zipper teeth if
the zipper becomes difficult to pull.
Clean the vacuum/blower tube with a brush upon
evidence of dirt and grime.
Dirt and grime can make the switch
(blower/vacuum) more difficult to operate as a
result of the material that swirls up off the
ground. When this occurs, simply flip the switch
back and forth a few times, which should bring it
back to the normal feel.
8.2 Maintenance
Should the tool experience problems beyond
those mentioned above, let only an authorized
professional or a customer service shop perform
an inspection.
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
Anleitung_BG_EL_2301_2501E_SPK7:_ 27.05.2009 8:37 Uhr Seite 15
