5. Poor surface quality on the planed workpiece:
Blunt knife. Replace knife.
Uneven feed. Feed the workpiece at constant
pressure and reduced feed speed.
Dust extraction system (not supplied) not
connected. Connect dust extraction system.
6. Chip discharge for surfacing or thicknessing
blocked:
Dust extraction system (not supplied) not
connected. Connect dust extraction system.
Wood too wet.
7. Uneven feed speed for thicknessing:
Rubber belt too loose. Check rubber belt and
replace if necessary.
Thicknessing table (20) soiled. Clean the
thicknessing table (20) and treat with a lubricant
if necessary.
16. Ordering replacement parts
Please provide the following information on
all orders for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
15
GB
Anleitung EHM_1300_SPK1:_ 18.12.2006 8:20 Uhr Seite 15
