4
GB
1. General Safety Remarks
Attention!
To avoid injury, follow this general safety
advice:
This underframe is designed for fixing mitre
saws/sliding mitre saws and supporting longer
workpieces. The underframe must be used on an
even and tidy ground.
When using this mitre saw underframe, always fix the
saw well with all 4 screws.
Do not overload the base frame.
Follow the general safety principles for woodworking
tools.
Follow the instruction manual and safety advice of the
mitre saw that you use with this base frame
2. Assembling the base frame (Fig. 1-4)
앬
Place the item on a support with its underside
facing upwards. Push the button (10) and turn the
feet (6) to the automatic fixing position. The button
will lock with a noise.
앬
Turn the frame over and insert the supporting
rollers (9) on the left and right into the mounts (7)
on the side extension arms (3). In doing so, make
sure the plastic guides (11) are positioned in the
mounts (7).
앬
Place both adjustable fixing bars (1) on the two
tubes (2) of the frame and secure with the aid of
the crank (5).
3. Attaching the device to the base
frame (Fig. 5-7)
Important: Before attaching the machine to the
base frame, the base frame must be tightly
screwed to the floor!
앬
To attach the saw, insert the 4 fixing screws (12)
into the adjustable fixing bars (1).
앬
Slacken both fixing bars (1) by cranking towards
the left, adjust the saw to the distance of the
mounting holes and then re-secure the fixing bars
by cranking towards the right.
앬
Align the fixing screws (12) in such a way that
they correspond to the mounting holes of the saw
(see Figure 6).
앬
Place the saw on the base frame in such a way
that the screws fit through the mounting holes.
앬
Secure the saw to the base frame with the aid of
the hexagonal nuts and washers provided (Fig. 7).
4. Adjusting the supports (Fig. 8-9)
앬
The supporting rollers for the workpiece must be
adjusted to the support height of the saw. To do
this, slacken the knurled screw (8), adjust the
supporting roller (9) to the desired height and re-
secure with the knurled screw (8).
앬
The extension arms (3) for the supporting rollers
(9) can also be adjusted in length in order for
them to match the workpiece optimally. To do this,
slacken the thumb screws (4), pull out the
extension arm (3) to the desired length (approxi-
mately 45 cm each) and re-secure with the thumb
screws (4).
5. Maintenance
앬
In order to ensure good mobility of the compo-
nents, dirt must be removed regularly and all
moving parts (rollers, extension arms) must be
lubricated at regular intervals. Cleaning is best
carried out with compressed air or a rag.
앬
Never use caustic agents to clean plastic parts.
6. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬
Type of machine
앬
Article number of the machine
앬
Identification number of the machine
앬
Replacement part number of the part required
Anleitung_Untergestell_EX_AUS_SPK7__ 05.11.12 10:18 Seite 4