GB
- 26 -
12. Troubleshooting Guide
Problem
Possible Cause
Solution
No material exits
from the nozzle
Nozzle clogged
Material tube clogged
Max. paint volume control rotated too far
anti-clockwise (-).
Material tube is loose.
No pressure build-up in the container.
Consistency of the material is too thick.
Clean
Clean
Turn clockwise (+)
Insert
Tighten container
Dilute
Material drips from
nozzle after spray-
ing
Nozzle is loose.
Nozzle is worn.
Nozzle seal is worn.
Solids in the air cap or nozzle.
Tighten
Replace
Replace
Clean
Atomization too
coarse
Material viscosity too high
Material volume too high
Max. paint volume control turned too far
clockwise (+).
Dirty nozzle.
Insu
ffi
cient pressure build-up in the con-
tainer
Dilute
Turn the max. paint volume con-
trol anti-clockwise (-)
Clean
Tighten the container
Intermittent („
fl
utte-
ring“) spray
Almost all of the material in the container
has been used up.
Add more
Coating pattern is
too light and uneven
You moved the paint spray gun too fast ac-
ross the surface you are working on.
Move the gun more slowly.
The paint runs or
sags.
You applied too much material.
Turn the max. paint volume con-
trol anti-clockwise (-)
Excessive spray
mist
The gun is held too far away from the object
you are working on.
Hold the gun closer.
Turn the max. paint volume con-
trol anti-clockwise (-)
Anl_TC_SY_400_500_SPK9.indb 26
Anl_TC_SY_400_500_SPK9.indb 26
07.06.2018 08:29:20
07.06.2018 08:29:20
