GB
- 12 -
Actuate the cleaning button (1) six times while
the equipment is in operation with the end of the
suction hose. Keep the button pressed down for
4 seconds each time you actuate it. Ensure that
the suction hose does not become kinked when
you do so.
6.7 Cleaning the
fi
lter (Fig. 1/5)
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the equipment.
6.8 Cleaning the tank (Fig. 1/10)
The tank can be cleaned with a damp cloth and
some soft soap or under running water, depen-
ding on the amount of dirt.
6.9 Cleaning the
fi
lters
Cleaning the pleated
fi
lter (Fig. 3/24)
Clean the pleated
fi
lter (24) regularly by carefully
patting it and cleaning it with a
fi
ne brush or hand
brush.
Cleaning the foam
fi
lter (Fig. 3/25)
Clean the foam
fi
lter (25) with a little soft soap un-
der running water and allow it to air-dry.
Cleaning the
fi
lter (Fig. 20a-20b)
The
fi
lter (2) should be checked at regular inter-
vals and cleaned if necessary.
1. Remove
the
fi
lter cover (2) (Fig. 20a).
2. Take out the
fi
lter (2) (Fig. 20b).
3. Clean
the
fi
lter by tapping it or blowing it out.
4. Assemble in reverse order
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
Warning!
Maintenance and cleaning work must be perfor-
med in such a way that no danger is created for
maintenance personnel or any other persons.
When maintenance and repair work is carried out,
all contaminated parts which cannot be su
ffi
cient-
ly cleaned must be packed in impermeable bags
and disposed of in accordance with the appli-
cable regulations in force in your country.
In the maintenance work area:
•
Ensure that filtered forced ventilation is provi-
ded
•
Wear personal protective equipment
•
Clean the maintenance work area after com-
pletion of the maintenance work
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend cleaning the equipment im-
mediately each time after use.
8.2 Maintenance
At regular intervals and before each use, check
that the
fi
lters in the wet and dry vacuum cleaner
are securely
fi
tted.
A dust-related inspection, e.g. for damage to the
fi
lter or for leaks in the vacuum cleaner, must be
carried out at least once a year by the manufactu-
rer or an instructed person.
8.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Anl_TE_VC_2230_SACL_UKCA_SPK7.indb 12
Anl_TE_VC_2230_SACL_UKCA_SPK7.indb 12
11.01.2022 09:48:55
11.01.2022 09:48:55
