7
3. Installation
The appliance can be used indoors in a free standing
position. Keep a minimum distance of 0,5 m between
the housing and walls, combustible materials
(furniture, curtains, etc.). The fan heater may only be
used completely mounted and standing vertically on
a stable surface. It is prohibited to operate the
appliance on an instable surface (e.g. on a bed).
4. Technical data:
Rated voltage
230 V ~ 50 Hz
Output:
1200 W (3 x 400 W)
Mains lead:
3 x 0.75 mm
2
x 1.5 m
Machine dimensions incl. foot approx.:
40 x 30 x 62 cm
5. Proper use
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
6. Fitting the supporting foot
앬
Guide the mains cable through the recess in the
middle of the supporting foot.
앬
Fit the heater into the recess (Figure 2).
앬
Fasten the heater to the supporting foot with the
two thumb screws (1) (Figure 3).
앬
Feed the mains cable (2) through the guides (3) in
the supporting foot to the outside as illustrated
(Figure 3).
7. Starting up
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate. Read
safety instructions listed under section 1.
When the heater is used for the first time or after a
long period of rest it may emit an odor for a short
time. This is not a fault.
7.1 Topple cut-out
If the appliance topples during operation, it is
automatically turned off by the switch (Fig. 3/Item 4).
When the heater is placed upright again (the switch
(Fig. /Item 4) must be activated), the appliance
restarts immediately.
7.2 Output and oscillation (Fig. 4)
Pressing the main switch (1) activates the
machine at a rating of 400 W. One halogen
heating element will be lit.
In addition you can activate two other heating
elements with a rating of 400 W each using the
other two heating switches (2 / 3).
In addition to the main switch (1) you can activate
the oscillation system using the oscillating switch
(4). This will cause the heater to swing to the left
and right. The maximum oscillating angle is 75°.
Pressing the various switches (2-4) again will
switch off the heating elements or oscillation
system.
The machine can be switched off completely by
pressing the main switch (1) a second time.
8. Maintenance and cleaning
앬
Before carrying out any cleaning and maintenance
work the appliance must be turned off,
disconnected from the power supply and cooled
down.
앬
Maintenance and repair work may only be carried
out by an electrical servicing contractor or your
customer service center.
앬
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or the customer
service responsible for your country in compliance
with the relevant regulations.
앬
Use a damp cloth to clean the casing.
앬
Remove dust pollution with a vacuum cleaner.
9. Storage
The radiator has to be stored in a dry place, covered
if possible.
GB
Anleitung HH 1200_SPK1:Anleitung HKL 2000 D 09.03.2007 7:18 Uhr Seite 7