7
1. Description
1
Power cable
2
Locking button
3
On/Off switch
4
Knurled screw for regulating the speed
5
Inspection guard
6
Saw blade
7
Guide roller
8
Adjustable base
9
Selector switch for pendulum action
10 Adapter for chip extractor
11 Allen key
12 Parallel stop
13 On/Off switsch Laser
2. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Important!
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from acci-
dents by taking the appropriate precautionary mea-
sures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open the laser module.
When the device is not going to be used for
an extended period of time, the batteries should
be removed.
STARTING UP
Instant response operation
(Figure 1)
Switching on: Press the On/Off switch
Switching off:
Release the On/Off switch
Continuous operation
Switching on:
Press the On/Off switch, keep pres
sed and lock with the locking button
Switching off:
Press the On/Off switch and release
Electronic speed control setting
(Figure 3)
Using the knurled screw on the On/Off switch you
can pre-set any speed. Turn the knurled screw in
PLUS direction for a higher speed and turn it in
MINUS direction for a lower speed. The ideal cutting
rate depends on the specific material and working
conditions.
The general rules for tool speed in cutting operations
apply.
Changing the saw blade
(Figure 2)
Switch off the jigsaw and remove the plug from the
power socket before changing the blade or carrying
out any other work on the jigsaw.
Use the supplied hexagon-socket spanner to undo
the two screws on the ram (Figure 2). Slide the saw
blade into the guide slot and up to the stop between
the piston rod and the retention clip. Use the
supplied hexagon-socket spanner to tighten the two
screws. The teeth of the saw blade must face in
cutting direction. Make sure that the saw blade sits
properly in the guide slot of the ram and roller.
Adjusting the base
(Figure 4)
For miter cuts and angular cuts you can swivel the
soleplate by up to 45° to either side after undoing the
screw at the rear. Angles of 15°, 30° and 45° are
marked. Settings between the markings are also
possible without difficulty.
To adjust the cutting angle, undo the two screws
(Figure 4) until you can just about move the blade.
Adjust to the required angle and re-tighten the two
screws.
Dust extraction
The jigsaw is equipped with a dust extractor socket.
Mount the adapter on the jigsaw and fix it in place by
twisting. Any vacuum cleaner can be connected to
the socket at the rear of the jigsaw. If you require a
special adapter, please contact the manufacturer of
your vacuum cleaner.
GB
Anleitung E-PST 710 Laser 08.04.2004 13:43 Uhr Seite 7
