Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
Safety Information
Please refer to the booklet included in delivery for the
safety instructions.
Proper use
You can use the hot glue gun to glue the follow-
ing materials: Wood, plastics, textiles, card-
board, ceramics, leather, etc.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications.
Our warranty will be voided if the equipment is
used in commercial, trade or industrial businesses
or for equivalent purposes.
Layout (Fig. 1)
1 Nozzle
2 Support stand
3 Trigger lever
4 Glue stick
Putting into operation
Fix the clip-rest onto the front of the hot glue gun.
Fold the clip forwards so that it locks securely into
place in the foremost setting before inserting the
power plug into the power outlet.
Always put the hot glue gun down on a non-flamma-
ble surface.
Push a glue cartridge into the hot glue gun as far as
the limit stop. Now insert the power plug into the
power outlet. The glue gun will be ready for use after
a warm-up time of approx. 5 minutes.
Squeeze the trigger to apply the glue in drops or
strips depending on which nozzle is used.
Press both surfaces together immediately. The
adhesion time is approx. 30 seconds.
During interruptions and upon completing the work,
always use the clip-rest to support the hot glue gun.
Caution!
Glue stains on textiles cannot be removed
Technical data
Power supply
230 V ~ 50 Hz
Power input
25 (78) W
Heat-up time
approx. 5 mins
Melting point
approx. 140°C
Working temperature
approx. 170°C
Glue stick Ø
11 mm
Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
4
GB
Anleitung BKP 200_SPK1:Anleitung BKP 200_SPK1 11.10.2006 9:30 Uhr Seite 4
