12
The machine should only work under supervision of somebody. Plug
and switch the machine off if it is not under supervision, e. g. in case of
putting up and stripping down the machine, in case of setting up and
striking, voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Do not use the machine if one part of the housing is damaged or in
case of damages on the switch, cable or plug.
Pay attention that the speed indicated on any disc or tool meets or is
higher than the max. speed indicated on the machine.
Grinding wheels have to be stored and used carefully and following the
instructions of the producer.
Check the accessories before use. Do not use any products which are
broken away, cracked or damaged in another way.
Before use, make sure that the tool is correctly fixed and fastened.
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
In case of using grinding tools with internal thread, make sure that the
internal thread is long enough to receipt the whole spindle thread
length.
While working, lead the line cord or extension cord to the back away
from the tool.
Electric tools have to be inspected by a specialist in regular intervals.
Never carry the tool at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
When working with this tool, wear ear protectors, dust mask and
goggles.
Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
Always hold the tool with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Electrical Connection
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The grinder is made in protection class II.
The machine is equipped with a soft start which prevents that swift
automatic circuit breakers are unintentionally triggered.