EIBENSTOCK EPO 1310, Original Instructions Manual

Page: 15 / 20

15
A 1300
B 1600
C 1900
D 2200
E 2500
F 2800
G 3050
A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
Retooling
Attention!
Before any work on the tool, disconnect the plug from the
mains!
Actuate the spindle stop and keep it pressed.
Mount or remove the tool.
In order to check whether the spindle stop is
released before you switch on the tool, turn the
spindle slightly.
First, mount the sanding disc with velcro-type fastening on the work
spindle. Screw it on and tighten it by means of a jaw wrench SW 22. In
order to hold up, use the spindle stop.
Press the grinding wheel which is necessary for
your application on the sanding disc with
velcro-type fastening. Pay attention that the
sanding disc is well-positioned on the tool, in
fact as exact as possible. This allows a quiet
run of the machine.
Let the machine run for a short period of time and in a safe position. If the
machine does not run easily, stop working immediately.
Switch the machine on and put it carefully on the surface you want to work
on. Hold the tool with both hands and work with circular or linear
movements. Never put on the whole surface of the sanding disc. Always
grind with a small angle between grinding disc and the surface of the
workpiece.
Overload Protection