EIBENSTOCK EPG 400 A, Original Instructions Manual, Page: 13 / 44

13
Supply
Case including plaster milling machine with 2 pieces Li-ion battery pack
18V / 5,2 Ah, charger, base plate, sponge board and manual.
Application for Indented Purpose
When used with the appropriate equipment, the plaster milling machine
EPG 400 A
is suitable for machining lime-cement- and gypsum-based
surfaces, for sgraffito purposes and for smoothening insulting boards in the
case of full heat protection. Use only original CAS (Cordless Alliance
System) battery packs.
Available Accessories
Pos. Order No. Article Application
1 37731000 Li-ion battery pack
2 37734000 Charger Standard charging time ca. 110 min
3 37732000 Quick - Charger charging time ca. 45 min
4 37721000 Base plate (Klett)
Ø 370 mm
basic holder for all Klett
disks
5 37722000 Sponge board
Ø 400 mm
for smoothening lime-
cement-based plasters
6 37725000 Sponge rubber disk
Ø 380 mm
for smoothening lime-
cement- and gypsum-based
plasters
7 37729000 Felt disk
Ø 395 mm
for smoothening lime-
cement-based plasters
8 37728000 Smoothing disk
Ø 380 mm
for smoothing concrete
9 37724000 Scratch disk
Ø 370 mm
for sgraffito purposes
10 37726000 Plaster plane
Ø 385 mm
for smoothening lime-
cement-based plasters
11 3772A000 Scratch-
and Plaster-
plane Ø 370 mm
for smoothening lime-
cement-based plasters and
for sgraffito purposes
12 37727000
Abrasive disk corundum
P24
Ø 370 mm
for smoothening insulating
boards in the case of full
heat protection