EIBENSTOCK EBM 352/3, Original Instructions Manual, Page: 24 / 132

24
Using the Drilling Unit
In order to operate safely, please observe the following instructions:
Safety at work:

Make sure that your work place is free of anything that might disturb
your work.

Pay attention that your work-place is well-lit.

Make sure that you observe the conditions for the connection with the
power supply.

When laying the cables, make sure that it cannot be damaged by the
tool.

Make sure that you always can overlook the work place in a sufficient
way and that you always can reach all necessary control elements
and safety devices.

In order to avoid accidents, keep other persons away from your work
place.
Required space for operation and maintenance
If possible, make sure that you have enough free space for operation and
maintenance around the machine (about 2 metres). This way, you can work
safely and in case of operating trouble you can intervene immediately.
Preparation

When you drill into blocs, make sure that the blocs are well anchored
and fixed.

Before drilling in supporting parts, make sure that you do not
disregard the statics. Observe the instructions of the experts who are
responsible for the design.

Make sure that you do not damage any gas mains, water mains or
electric cables while drilling.

Pay attention that you do not touch any metallic parts of the machine
when you drill walls and grounds where electric cables could lie under
water.

Pay attention that the drilling core does not hurt anybody or damaging
anything when it drops out.

If the drilling core might cause any damage when it drops out, use an
device that can hold back the drilling core.

Make sure that the drill bit is well fixed.

Only use tools which are suitable for the particular material.