EHEIM thermocontrol+ 150, Operating Manual

Page: 14 / 128

English
14
Commissioning
Installing the heater (⌦A)
1. Remove the transportation protection
e
.
2. Connect the suction device
c
to the suction device mount
b
.
3. Connect the suction device mount to the heater (not in the
area of the heating zone
d
, the control light
f
and the status
LED
g
).
4. Attach the appliance below water level on the inside of your
aquarium (⌦B/C). Take the minimum water level into account.
▶ The heater must be rinsed well in order to guarantee consistent
water heating. Therefore, place the heater in an area with a
strong flow.
▶ Only install the heater in a vertical position.
Operation
System requirement
WLAN-enabled terminal device (smartphone, tablet, notebook etc.)
Creating the network
1. Insert the mains plug in the mains socket. The status LED
g
illuminates.
‧ The status LED flashes white: The network is being searched
for or created
‧ The status LED illuminates blue: A new network has been
created (master mode)
Connecting to the WLAN network
2. Open the network settings of your terminal device (smartphone,
tablet, notebook etc.).
3. Connect the terminal device to the WLAN network (SSID)
EHEIM heater XXXXXXXX.
4. Enter the network security key.
The SSID and network security key are found on the mains cable’s
label. Alternatively, you can also scan the QR code 1 (see label) to
establish the connection.
Calling up the website
5. Open your web browser and enter the following address:
http://192.168.1.1
Alternatively, you can also scan the QR code 2 (see label) to open
the software in the browser.
Initial configuration
6. Select the desired language from the language selection and
follow the instructions for the initial configuration.
A comprehensive set of instructions for the software can be found on
the main page via the QR code, or downloaded at www.eheim.com.
Meaning of the control light
f
‧ The control light illuminates red: Heater heats sufficiently
‧ The control light is off: Heater does not heat
Meaning of the status LED
g
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: Heater is in master mode
‧ The status LED illuminates green: The heater is connected to another EHEIM
digital device
‧ Danger of burning! The appliance is very hot
during and directly after operation. Never
touch hot parts or the heating zone!