56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1620/ST1620-FC
23
slight tremor of the trimmer head when trimming the grass, it is the cutting line being
automatically released.
WARNING:
Do not remove or alter the line-cutting blade assembly. Excessive line
length will cause the motor to overheat and may result in serious personal injury.
LINE REPLACEMENT
WARNING:
Never use metal-reinforced line, wire, or rope, etc. These can break
off and become dangerous projectiles.
WARNING:
Always use the recommended nylon cutting line with a diameter of
0.095 in. (2.4 mm). Using line other than that specified may cause the tool to overheat
or become damaged.
The string trimmer is equipped with an advanced POWERLOAD
TM
system. The cutting
line can be wound onto the spool simply by pressing a single button. Loading a full
spool can usually be completed in 12 seconds.
Avoid repeated operation of the
winding system in rapid succession to reduce the possibility of motor damage.
1. Remove the battery pack from the trimmer.
2. Cut one piece of cutting line
14 ft. (4 m) long.
3. Insert the line into the eyelet
(Fig. 21) and push the line until the
end of the line comes out of the
opposite eyelet.
NOTICE:
It is not necessary to align the
eyelets in order to insert the cutting line. If
the line cannot be inserted into the eyelet,
mount the battery pack onto the trimmer,
then press the POWERLOAD button briefly to reset the winding mechanism.
4. Remove the battery pack if it has been mounted onto the trimmer in step 3.
21
Eyelet
Lower Cover
Cutting Line
