EGO Power+ ST1511E, Operator'S Manual

Page: 15 / 382

56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E
15
EN
3. Following the instructions in “RELOAD THE CUTTING
LINE”
section in this manual to mount the lower
cover assembly.
4. Follow the instructions in “LINE REPLACEMENT”
section in this manual to reload the cutting line.
5. Start the tool to see whether the line trimmer
will work normally. If it does not, reassemble as
described above.
Fig. Z parts description see below:
Z-1 Spline Z-2 Key Slot
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Inspect and maintain the machine
regularly. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
WARNING:
Battery tools do not have to be plugged
into an electrical outlet; therefore, they are always in
operating condition. To prevent serious personal injury,
take extra precautions and care when performing
maintenance, service or for changing the cutting
attachment or other attachments.
WARNING:
To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing add-on attachments or removing
material from the unit.
CLEANING THE UNIT
◾
Clean the unit using a damp cloth with a mild detergent.
◾
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils, such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a shock
hazard. Wipe off any moisture with a soft dry cloth.
◾
Use a small brush or the air discharge from a small
vacuum cleaner brush to clean the air vents on the
rear housing.
SHARPEN THE LINE-CUTTING BLADE
WARNING:
Always protect your hands by wearing
heavy gloves when performing any maintenance on the
line-cutting blade.
1. Remove the line-cutting blade from the guard.
2. Wear proper eye protection and gloves and be careful
not to cut yourself.
3. Secure the blade in a vise.
4. Carefully file the cutting edges of the blade with a
fine-tooth file or sharpening stone, maintaining the
original cutting edge angle.
5. Replace the blade on the guard and secure it in place
with the two screws.
STORING THE UNIT
◾
Remove the battery pack from the line trimmer when
it is not in use.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-up or
up high, out of the reach of children. Do not store the unit
on or adjacent to fertilizers, petrol, or other chemicals.
Protecting the environment
Do not dispose of electrical equipment,
battery charger and batteries/rechargeable
batteries into household waste!
According to the European law
2012/19/EU, electrical and electronic
equipment that is no longer usable,and
according to the European law
2006/66/EC, defective or used battery
packs/batteries, must be collected
separately.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get
into the food chain, damaging your health
and well-being.