6
EN
ROTOCUT — RTX2300
CE
This product is in
accordance with applicable
EC directives.
V
Volt
Voltage
n
0
No Load
Speed
Rotational speed, at no load
min
-1
Per Minute Revolutions per minute
Direct
Current
Type or a characteristic of
current
kg
Kilogram
Weight
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
◾
Avoid Dangerous Environments
– Don‘t use
appliances on damp or wet slope.
◾
Keep guards in place and in working order.
◾
Keep hands and feet away from the cutting area.
◾
To reduce the risk of injury, never work on a ladder
or on any other insecure support. Never hold the
cutting unit above waist height.
◾
Check the cutting unit at regular short intervals
during operation, or immediately if there is a
noticeable change in cutting behavior.
◾
For best results, your battery should be charged in
a location where the temperature is greater than
5° C and less than 40° C
. Do not store it outside or
in vehicles.
◾
If you are approached, stop the motor and cutting unit.
◾
Warn the operator of the danger of blade thrust.
◾
Blade thrust may occur when the spinning blade
contacts an object that it does not immediately cut.
◾
Blade thrust can be violent enough to cause the unit
and/or operator to be propelled in any direction, and
possibly lose control of the unit.
◾
Blade thrust can occur without warning if the blade
snags, stalls or binds.
◾
Blade thrust is more likely to occur in areas where it is
difficult to see the material being cut.
◾
Do not attach any blade to a unit without proper
installation of all required parts. Failure to use the
proper parts can cause the blade to fly off and
seriously injure the operator and/or bystanders.
Discard blades that are bent, warped, cracked,
broken, or damaged in any way. Use a sharp blade
A dull blade is more likely to snag and thrust.
◾
A coasting blade/line can cause injury while it
continues to spin after the motor is stopped or
trigger is released. Maintain proper control until
the blade/line has completely stopped rotating.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition.
Be aware of possible hazards
even when the tool is not operating. Take care when
performing maintenance or service.
◾
Do not wash with a hose; avoid getting water in
motor and electrical connections.
◾
If situations occur that are not covered in this
manual, use care and good judgment. Contact the
EGO Customer Service Center for assistance.
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
No-load Speed
Up to 450/min
Cutting Blade
ABR2300
Recommended Operating
Temperature
0°C-40°C
Recommended Storage
Temperature
-20°C-70°C
Optimum Charging
Temperature
5°C-40°C
Weight
1.9 kg
Measured sound power
level L
WA
96.1 dB(A)
K = 3.8 dB (A)
Sound pressure level at
operator’s ear L
PA
83.2 dB(A)
K = 2.5 dB(A)
Guaranteed sound power
level L
WA
(measured according to
2000/14/EC)
100 dB(A)
Valuation of
vibration a
h
:
Machine
With
STX3800
With
BCX3800
Left handle
0.7 m/s
2
K = 1.5 m/s
2
0.6 m/s
2
K = 1.5 m/s
2
Right
handle
