POLE SAW ATTACHMENT — PSX2500/PSX2500-FC
24
Disassembling the Worn Bar and Chain (Fig. 9)
1. Switch off the tool and remove the battery.
2. Position the pole saw attachment on its side on a firm, flat surface, so that the
chain-sprocket cover is facing upwards.
3. Wear gloves. Using the combi-wrench provided with the power pole, loosen the
cover nut
COUNTERCLOCKWISE
and remove it from the chain-sprocket cover.
4. Remove the chain-sprocket cover from the pole saw attachment. Clean the chain-
sprocket cover with a dry cloth.
5. Remove the bar and chain from the mounting surface. Remove the worn chain
from the bar.
9
Sprocket
Chain-sprocket Cover
Chain-tensioning Screw
Cover Nut
NOTICE:
If there is difficulty in removing the bar and chain from the mounting surface,
place the pole saw upright, with one hand support the bar, to loosen the tensioning
screw
CLOCKWISE
with the other hand and then remove the bar with the chain.
NOTICE:
This is a good time to inspect the drive sprocket for excessive wear or
damage.