Ego Power+ SNT2400E, Operator'S Manual

Page: 21 / 21

56-VOLT LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400E
19
EN
TROUBLESHOOTING
WARNING:
Always remove the battery pack(s) when servicing or transporting the snow blower. Always protect
your hands by wearing gloves when performing any maintenance on the snow blower auger or scraper.
PROBLEM CAUSE SOLUTION
Snow blower is not starting.
◾
Battery charge is low.
◾
Charge the battery.
◾
The auger-switch trigger is not
depressed at the moment of the LED
indicator flashing green.
◾
Press the auger switch trigger when
the LED indicator blinks. If the LED
indicator stops blinking, the snow
blower will not be response to the
pressing of auger-switch trigger.
◾
The auger is frozen by snow or ice.
◾
Remove the battery pack(s) firstly, use
the supplied chute clean tool to clear
the snow or ice that obstructs on the
auger. Restart the snow blower.
◾
The battery is overteated. The LED
indicator on the battery flashes
orange or shines red (see the section
“BATTERY HIGH-TEMPERATURE
PROTECTION” in this manual)
.
◾
Remove the overheated battery
from the snow blower and wait
until the battery pack cools down to
approximately 67°C, then reinstall the
battery and restart the snow blower.
The motor is on but the auger
does not turn on.
◾
The shear pin is broken.
◾
Replace the shear pin following the
section “REPLACING THE SHEAR PIN”
in this manual.
The LED light button is
insensitive to the first pressing.
◾
The internal self-checking process
causes a slight delay in the first
keystroke response
.
◾
Press the LED light button and hold for
1 second
.
The LED indicator on th
e
battery keeps on after the snow
blower auger stops working or
self-propel system turns off
.
◾
The electric circuit is in standby for
next restart. The LED will shut off
automatically if the snow blower is
not operated in 5 to 10 mintues.
◾
Just leave it or remove the batteries
from the battery compartment.
WARRANTY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.