Ego Power+ HTX6500/4215 Original Instructions Manual Download Page 10

HEDGE TRIMMER — HTX6500/4215

10

EN

Blade Guard

The outer part of the blades is shaped as blade guards 
(Fig. N).

 WARNING: 

Always check that the blade guard is not 

damaged or distorted. Replace it if it is bent or damaged.

MAINTENANCE

 WARNING: 

When servicing, use only identical 

replacement parts. Use of any other parts may create a 
hazard or cause product damage. To ensure safety and 
reliability, all repairs should be performed by a qualified 
service technician.

 WARNING: 

To avoid serious personal injury, always 

remove the battery pack from the product when cleaning 
or performing any maintenance.

CLEANING

 

Use a soft brush to remove debris from all air intakes 
and cutting blade.

 

To remove pitch and other sticky residue, spray the 
blades with resin solvent. Run the motor briefly so that 
the solvent is evenly distributed.

 

Wipe the surface with a dry cloth

 WARNING: 

Never use water for cleaning your 

trimmer. Avoid using solvents when cleaning plastic 
parts. Most plastics are susceptible to damage from 
various types of commercial solvents. Use clean clothes to 
remove dirt, dust, oil, grease, etc.

SHARPENING THE CUTTING BLADE

1.  Remove the battery pack from your hedge trimmer.
2.  Clamp the blade assembly in a vise and file the 

exposed cutting surface of each blade tooth. Remove 
as little material as possible.

3.  Remove the hedge trimmer from the vise and adjust 

the unsharpened blade on the other side exposed. 
Repeat the above procedures until all the blade teeth 
sharpened.

NOTICE:

 Do not operate your hedge trimmer with dull or 

damaged cutting blades. This may cause overload and 
will give unsatisfactory cutting results.

LUBRICATING THE BLADE

For best operation and longer blade life, lubricate the 
hedge trimmer blade with light weight machine oil before 
and after each use.

Remove the battery pack and lay the trimmer onto a flat 
surface. Apply the oil along the edge of the top blade as 
Fig. O shown.

NOTICE: 

For extended using period, oil the blade during 

cutting operation.

 WARNING: 

Do not oil while the hedge trimmer is 

running.

TRANSPORTING AND STORING

 

Always place the shield on the blade before storing or 
transporting the hedge trimmer. Use caution to avoid 
the sharp teeth of the blade.

 

Clean the hedge trimmer thoroughly before storing.

 

Store the hedge trimmer indoors, in a dry place that is 
inaccessible to children.

 

Keep away from corrosive agents such as garden 
chemicals and deicing salts.

 WARNING: 

Blades are sharp. When handling the 

blade assembly, wear non-slip, heavy-duty protective 
gloves. Do not place your hand or fingers between blades 
or in any position where they could get pinched or cut. 
NEVER touch blades or service the unit with battery pack 
installed.

Summary of Contents for HTX6500/4215













Reviews: