Ega Master MasterEx Ex-PMR 1000, Operating Instructions Manual, Page: 24 / 48

-24-
Please observe
:
In order not to select any pilot tone, select the pilot tone number “0”. Press PTT and hold it for approx. 2 seconds, until a one-second
tone sounds.
If PTT is pressed more often than 9 times, a warning tone sounds and no value is selected.
7. The respective signal tone of the selected number sounds after 2 seconds.
8. The setting is completed by pressing the monitor key. The green LED display flashes two times.
9. Pressing the Monitor key again confirms the signal tone of the selected number.
10. Program another channel just the same as in the above steps 3-9.
Example : Changing a channel storage space (2) with CTCSS – pilot tone No. 25
1. Select channel storage space 2 in the CTCSS/DCS set mode.
2. Press PTT 2 times to select 2 for the “tens” digit.
3. After 2 seconds, 2 short signal tones confirm that 2 has been selected.
4. Press PTT 5 times to select 5 for the “units” digit. Each time you press it, a signal tone will sound.
5. After 2 seconds, 5 short signal tones confirm that 5 has been selected.
6. Press the monitor key and the green LED display flashes two times.
7. Press the monitor key again. Two short signal tones will sound and - after a short pause - 5 short signal tones, to confirm the
selection of 25.
8.4.4 Checking the channel storage space settings
You can check the settings of your radio unit.
:
After checking is complete, switch the unit off and back on again, so that it is back in the operating mode. No signal tone will sound if
“0” is selected for the “tens” digit.
1. Turn on the unit while pressing the PTT key. The radio unit goes into the check mode.
2. Select the channel storage space which you would like to check.
3. Press PTT and the signal tone sounds (that is, when channel number 8 is set, one long and three short signal tones sound).
4. Press the Monitor key and a signal tone sounds (that is, when pilot tone 25 is set on the channel, two short signal tones and after a
short pause, five additional tones will sound).
5. Turn the unit off when the check is complete.
Confirming the signal tone
Number Signal tone Number Signal tone
0 1 second tone 5 .....
1 . 6 -.
2 .. 7 -..
3 ... 8 -...
4 .... 9 -....
Default values of the channel
Channel number Frequenz CTCSS / DCS
1 1 (446,00625) 0 (OFF)
2 2 (446,01875) 0 (OFF)
3 3 (446,03125) 0 (OFF)
4 4 (446,04375) 0 (OFF)
5 5 (446,05625) 0 (OFF)
6 6 (446,06875) 0 (OFF)
7 7 (446,08125) 0 (OFF)
8 8 (446,09375) 0 (OFF)
9 1 (446,00625) 1 (67,0 Hz)
10 1 (446,00625) 39 (D023)
11 2 (446,01875) 1 (67,0 Hz)
12 2 (446,01875) 39 (D023)
13 3 (446,03125) 1 (67,0 Hz)
14 3 (446,03125) 39 (D023)
15 4 (446,04375) 1 (67,0 Hz)
16 (S) search run