EG4 8KEXP-240, User Manual

Page: 14 / 50

5.3 Mounting
➢
Installation Precaution
Inverter is designed for outdoor installation (IP 65). Make sure the installation site meets
the following conditions:
●
Not in direct sunlight.
●
Not in areas where highly Flammable materials are stored.
●
Not in potential explosive areas.
●
Not in the cold air directly.
●
Not near the television antennas or antenna cables.
●
Not higher than the altitude of about 4000m above sea level.
●
Not in environment of precipitation or humidity (
＞
95%).
●
Use in a well ventilated area.
●
The ambient temperature is in the range of -20
℃
to +60
℃
.
●
The slope of the wall should be within ± 5° .
●
When mounting the inverter on the wall must meet the conditions below:
1.solid brick/concrete, or strength equivalent mounting surface.
2.Inverter mount must be supported if the walls strength isn’t enough (such as wooden
wall, the wall covered by thick layer of decoration)
Please AVOID direct sunlight, rain exposure, snow laying up during installation and operation.
➢
Space Requirement
14