INSTALLATION INSTRUCTIONS
How to install the bicycle out of the box
1. Unpack the bicycle from the box and cut all the ties that held the bicycle together during
shipping.
2. Turn the front fork 180 degrees. If the fork cannot turn, loosen the screws holding the
handlebar stem and then turn the fork. Tighten the handlebar stem back after turning the fork
forward; such that the stem will protrude forward.
3. Install the handle bar onto the handlebar stem. An Allen key is supplied to install the handle
bar.
4. Remove the battery from the rack, so that it is easier to turn the bicycle upside down to install
the front wheel. To remove the battery, insert the keys into the lock and turn the key to unlatch
the battery. Gently slide the battery out from the holder.
5. ! WARNING: Please make sure that the saddle and the handle bar are installed properly
before turning the bicycle upside down to install the front wheel. Ensure the weight of the bike
does not bend the rear mudguard.
6. Turn the bicycle upside down such that the fork is facing upward.
7. Check the pattern of the tire such that when installed they will match the direction of the rear
tires and the motor connector on the same side to where you will connect the motor cable.
8. Install the front wheel by placing the wheel between the forks. Place the wheel past the front v-
brake.
9. ! NOTE: Please make sure the lock washers are in between the hub motor and the fork on
both sides of the hub motor.
2
