10
•
Make sure all fasteners are correctly tightened as written in the owner’s manual
•
Parts that are not properly tightened can be lost or operate poorly.
•
Do not over tighten parts, as over-tightening may damage the part.
•
Make sure any replacement fasteners are of the correct type and size.
•
Your bike uses an Aluminum Alloy frame. Ensure that the bicycle frame is carefully and
frequently inspected; as Aluminum frames can develop micro fractures from stress,
severe impact and shocks. If you see these micro fractures or cracks, stop riding the
bicycle immediately.
•
In case of micro fractures, have the bicycle frame repaired and inspected by a qualified
professional before riding the bicycle again.
NOTE: Have a bicycle service shop make any repairs or adjustments for which you do not have
the correct tools to or if you do not sufficiently understand the instructions set forth in this electric
bicycle’s manual supplement or the bicycle owner’s manual.
Inspection of the Bearings Maintenance
1.
Frequently check the bearings of the bicycle. Have a bicycle service shop lubricate the
bearing once a year or any time they do not pass the tests as noted in the Bicycle
owner’s manual.
Serial Numbers to your EG Electric Bike
There are 3 serial numbers that are of importance on your EG Electric Bike. They are the
Frame serial number, the Motor serial number and the Battery pack serial number. All the
serial numbers except for the battery's can be found on the outside of the box the bicycle
was shipped in.
The Bike Frame Serial number to your EG Electric Bike is located on bottom bracket tube
of the bike (where the pedal crank attaches to the bike) on the frame of the bike.
The Motor serial number is located on the side of the motor.
The Battery serial number is located near the output posts of the Battery pack.
How to detach the rear wheel of the Electric bike
1.
! WARNING: We do not condone modifying the EG Electric Bicycle in any way shape or
form. Modifying the bike in any way, will void your Warranty. The instructions below are
written only for the maintenance or repair of the bike.
2.
To detach the rear wheel, first unhook the connector near the rear wheel.
3.
Unscrew the nuts on both sides of the rear axle and the wheel should come right off.
4.
Unhook the chains from the rear freewheel (cogs)
5.
To install it back on, please note and reverse all the detachment instructions.
