EG Bali 350 Owner'S Manual Download Page 5

The motor will NOT stop when you stop peddling while the thumb throttle is engaged.

The motor will stop if the brake lever is depressed even if the thumb throttle is engaged. 

! CAUTION: Remember to let go of the thumb throttle when getting on or off the bike 
weather or not the brake levers are engaged.

In this mode, the electric bike will use the most amount of battery power it will use even 
more battery power than in any of the peddle assist modes.

This mode will give you the least “miles per charge” compared to any of the above modes 
of operation

About the Brake Safety Feature on all our Electric Bikes.

ALL our electric bikes make use of a wired brake lever kill switch for safety purposes. When 
the brake lever is engaged, it sends a kill signal to the controller to disable the motor under 
all circumstances and condition. This will ensure the motor does not continue to spin when 
you need the bicycle to stop. 

How to read the Battery Meters and about the Li-on battery 

 

battery pack for removal. You do not need to insert this key to operate the electrical system of the 
bicycle, nor do you need this key to insert the battery to lock it on to the bike.

! NOTE: The sole purpose of the smaller pair of keys is to turn the electrical system “ON/OFF”. You 
will need this key to operate the electric motor of your electric bike and this key does not unlock the 
battery latch. This key is used on the top ignition lock of your Electric Bike.

! WARNING: Please keep the 2 set of keys to your electric bicycle in a safe place. Each set of keys 
are unique to your particular electric bicycle and unfortunately we do not keep a copy of your keys on 
file. Nor would we have a way of reproducing them.

CARE INSTRUCTIONS

Battery

WARNING: 

Never short circuit the charge or discharge battery terminals.

5

Summary of Contents for Bali 350









Reviews: