
Z10-30
2. Long press (5 secs) menu button to enter settings manually. Numbers will
flash. Into corresponding settings page, use plus/minus keys to adjust
parameters to desired value. After completion cycling setting pages,
system will automatically store changes into memory and exit setup menu.
3. In any interface from 2 to 5, long press (UP) to enter settings (store into
memory).
•
Function declaration
1. The floating voltage: float start voltage
2. Discharge recovery voltage: refers to the battery discharge, protection the
battery voltage to restore voltage open the output
3. The discharge cut-off voltage: refers to the battery discharge voltage when
the load off, to protect the battery, to prevent the battery over discharge
damage
4. Load operation mode
(24H) Load output 24 hours (except for battery under voltage)
(1-23 H) Load on after sunset and closed after setting hours
(0H) Dusk to down
•
Note
1. The light control function is controlled by the solar panel, the use of light
control function must access the solar panel. Otherwise, the light control
will not have effect.
2. Load symbol
, only states that the load output has been turned on, and
there is no connection to the load.
3. 12V load outputs 120 W (max); 14V serves a maximum output of 240W.
The load cannot exceed the output power. If there is an inverter, the
inverter can be directly connected to the battery, because the inverter itself
comes with under voltage protection.
4. As long as it is not set to [1-23H] or [0H] (on optical display model) if battery
is not under pressure condition (battery icon does no blink), load output
can be turn on/off with a single short press on menu key.
5