26
Installation and Service Guide: Color Controller E-46A
Installing Hardware
To disable the power synchronization
1
Turn off the printer using the main power switch.
Wait until the E-46A shuts down.
2
Set the switch on the E-46A connector panel to the OFF position (see
3
Disconnect the USB power cable from the Type B USB port on the E-46A connector panel, and from the USB port
on the printer.
Completing the installation
To complete the installation of the E-46A at the customer site, do the following:
1
Make sure that the E-46A is turned off and the power switch on the E-46A connector panel is in the ON (|)
position.
2
Set the power synchronization switch on the E-46A connector panel to ON position (see
).
3
Power on the printer.
The E-46A automatically starts up.
4
Print the Configuration page from Fiery QuickTouch to obtain the Fiery ID that is used as a Fiery default password
(see
Note:
Fiery ID is referred to the ID field located under BIOS Setup section of the Configuration page.
5
Once the E-46A starts up, follow the on-screen prompts to complete the language selection, license agreement, and
enter the server name.
6
If the E-46A requires a static IP address (for example, in a non-DHCP network environment), work with the site
administrator to configure it as described on
7
Print the Test Page and Configuration page, and ask the customer to verify the output (see
8
Perform any required system software upgrades. For instructions, see the documentation that accompanies the E-
46A system upgrade.
Updates to E-46A software may be available from a variety of sources (for example, System Updates (see
)
or patches downloaded by the customer).
Windows operating system updates should be obtained from Microsoft directly. Because such updates are available
directly from Microsoft, EFI does not maintain or provide them via the System Updates feature.
Do not change the switch position when the E-46A is powered on.
Do not change the switch position when the E-46A is powered on.
