EFI E-45, Installation And Service Manual, Page: 100 / 126

100 Installation and Service Guide: Color Controller E-45
Installing System Software
The System Software installation takes approximately 1.5 hours to complete.
Note:
During the installation, you need to access the DVD drive often. Keep the front door open when you install the
system software.
Note:
If Fiery Impose or Fiery Compose is activated, you must deactivate them before you reinstall.
• Disconnect the network cable, crossover Ethernet cable, and printer interface cables from the back of the E-45 (see
Figure 3 on page 19).
If you do not, installation will fail.
1
Insert System Software DVD 1 into the DVD drive.
2
Reboot the E-45.
Wait while the system boots from the DVD.
3
When the language selection screen displays, select a language.
The language selection screen displays on the monitor and on Fiery QuickTouch. If you select a language on either
device, you will need to complete the entire installation on that device, and the other device’s screen will be locked for
the duration of the installation.
4
When “What do you want to do?” screen displays four choices, select
New Installation
.
5
When “This installation will erase all data on the hard disk drive(s). Continue?” message displays, select
Continue
.
6
After copying the System Software 1 DVD contents to the hard drive, eject DVD 1 and insert System Software DVD 2.
7
After copying the System Software DVD 2 contents to the hard drive, eject DVD 2 and insert System Software DVD 3.
8
After copying the System Software DVD 3 contents to the hard drive, eject DVD 3 and insert User Software DVD 4.
When you eject User Software DVD 4, the E-45 reboots to begin the software installation.
9
Wait while the E-45 complete the installation. This will take about 45 minutes.
The following steps are for use with a keyboard, monitor, and mouse. If you are not using a keyboard, monitor, and
mouse, skip to
step 15 .
10
When the E-45 becomes Idle, click the mouse to show the login screen on the monitor. Enter the Administrator’s
password and then press Enter.
Fiery.1
is the default password and is case-sensitive.
11
Ask the site administrator to follow the on-screen instructions in the Fiery Setup Wizard to configure the E-45 for the
customer’s print environment.
Once the configuration in the Fiery Setup Wizard is done, you must restart the server for the changes to take effect. If
desired, you can print a Server Configuration page after the restart to confirm the default settings.
For more information about the Fiery Setup Wizard, see Configuration and Setup , which is part of the user
documentation.