S
ETTING
UP
FROM
A
C
LIENT
C
OMPUTER
43
S
ETTING
UP
FROM
A
C
LIENT
C
OMPUTER
After you start the E-42B for the first time, or install system software, you must set up the
E-42B. If you do not, default settings are used. Make sure that settings are appropriate for
your printing environment. If your network or printing environment changes, you may need
to adjust your settings.
Set up from the copier control panel
Perform initial Setup from the copier control panel (see
). After initial Setup, you can
change options from a client computer.
Set up from a client computer
After you perform initial Setup from the copier control panel, you can change
most
options
from a client computer using Configure.
If you are setting up the E-42B for the first time, you can use the Fiery Setup Wizard to
configure language, regional, server, and print environment settings. For more information,
see
.
About Configure
You can find more information about using Configure the following ways:
•
If you access Configure from an Internet browser,
in WebTools, on the Configure tab, click
the Help icon.
•
If you access Configure from Command WorkStation,
see Command WorkStation Help.
T
O
ACCESS
C
ONFIGURE
FROM
AN
I
NTERNET
BROWSER
1 Open an Internet browser and type the IP address of the E-42B.
2 In WebTools, on the Configure tab, click Launch Configure.
3 Log on with Administrator privileges.
T
O
ACCESS
C
ONFIGURE
FROM
C
OMMAND
W
ORK
S
TATION
1 Start Command WorkStation.
2 Log on with Administrator privileges.
