I
NSTALLING
H
ARDWARE
17
Unpacking the E-42
The E-42 is assembled and shipped from the factory with all necessary cables (except the
network cable) and documentation.
• The E-42 weighs approximately 20Kg. Be careful when moving the device.
• Never lift the E-42 by grasping the top panel. The top panel does not support the weight of
the system.
A
VERTISSEMENT
:
Ne jamais soulever le serveur d'impression par sa partie supérieure : celle-ci ne peut pas supporter le
poids du système.
A
VVERTENZA
:
Il server di stampa non deve essere mai sollevato afferrandolo dal pannello superiore, in quanto
quest'ultimo non può sostenere il peso dell'intero sistema.
W
ARNUNG
:
Heben Sie den Druckserver nicht an der oberen Gehäuseabdeckung an. Die obere Gehäuseabdeckung ist
nicht dafür ausgelegt, das Gesamtgewicht des Systems zu tragen.
A
DVERTENCIA
:
No levante nunca el servidor de impresión agarrándolo por el panel superior. El panel superior no
soporta el peso del sistema.
A
VISO
:
Nunca erga o servidor de impressão pelo painel superior. O painel superior não suporta o peso do sistema.
W
AARSCHUWING
:
Til de afdrukserver nooit op door het bovenpaneel vast te nemen. Het bovenpaneel kan het gewicht
van het systeem niet dragen.
T
O
UNPACK
THE
E-42
1 Open the box and remove the packing material.
Save the original boxes and packing material, in case you need to transport the E-42 at a later
date.
2 Remove the contents from the top container. Inspect the contents for visible damage.
3 Set aside the remaining components from the top container.
4 Remove the top container and any packing material.
5 Carefully lift the E-42 out of the box.
If you notice shipping damage to any component, save the shipping container, in case the
carrier needs to see it. Call the carrier immediately to report the damage and file a claim.
6 Give the media pack to the customer or network administrator.
Let the customer or network administrator know that in order to take full advantage of the
E-42, the user software must be installed on computers that will print to the E-42.
7 Locate the EFI/Fiery decal in the shipping container and affix it to the copier/printer as
shown.
