15
Turning on the Appliance
PREMISE:
1.
Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the case,
the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2. Press current prog. Button more than 3 seconds to cancel the program ,
then you can change the program to the desired cycle setting (see the section
entitled " Starting a wash cycle. . . " ).
3. Press one of others prog. Button more than 3 seconds to cancel the runing program ,
translase the program which you press.
4. Press the delay button more than 3 seconds to re-edit delay time .
NOTE:
If you open the door when washing, the machine will pause. When you
close the door , the machine will keep on working after 10 seconds.
The Display window shows the state of the dishwasher:
a) Display window shows "--:--" --> stand by;
b) Display window shows "H:MM" and not blinking --> pause;
c) Display window shows "H:MM" and blinking --> run.
If display window shows error codes(page 21th), that indicates the machine is out of order,
please turn off the main power and water supply before calling a service.
NOTE:
1
Draw out the lower and upper basket, load the dishes and push them back.
It is commended That loading the lower basket first, than the upper one (see
the section entitled
"Loading the Dishwasher
2 Pour in the detergent (see the section e`ntitled Salt, Detergent and Rinse Aid ).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ,
the specification of the socket is 12 A 250 VAC. Make sure that the water supply is
turned on to full pressure.
“
”
”
).
4 Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
Press the Progragram Button to select a desired Wash cycle,After 3 seconds,the machine will work.
Starting a cycle wash