7
4- DISPENSER/PLUMBING INSTALLATION
Please follow all plumbing and dispenser instructions carefully. We recommend that this product be installed by
a licensed and qualified plumber in accordance with all applicable national, state, provincial, and local plumbing
codes.
DO NOT
install HotMax with a different dispenser or outlet hot water pipe that is not included in
packaging.
DISPENSER INSTALLATION INSTRUCTIONS
STEP 1:
Identify which hole in the sink basin will be used for the
new dispenser. The location for the dispenser must be within 20”
of HotMax and check to make sure there is sufficient clearance
for handles to be fully opened.
It is recommended to dry-fit the
heater and dispenser connected by the proprietary hot water
tube to ensure that the tube is long enough to reach between
the two.
The HotMax dispenser requires a 1.5 inch diameter hole
to be mounted in the sink basin or countertop.
NOTE:
HotMax Dispenser can replace a sink side spray and hose
(Figure 3)
CAUTION
If you have to drill through a sink or countertop, it is recommended to rent or purchase the
appropriate tools. If drilling into a surface other than stainless steel, consult a professional.
STEP 2:
Remove components from packaging and connect the dispenser, proprietary outlet tube and fittings.
See plumbing installation for more details.
DO NOT
pinch, break, or cut the proprietary outlet tubing. Be careful to not damage the fittings.
DO NOT
overtighten compression fittings. Ensure all fittings are properly seated in the base of the dispenser
head.
DO NOT
use pipe dope or Teflon Tape.
Use of pipe dope or Teflon tape may void the warranty.
STEP 3:
Insert the proprietary hot water outlet tube down
through the hole in the sink or countertop until the base of
the dispenser sits flush on the surface. Seal the dispenser
to the sink or countertop with an appropriate sealant
before proceeding with plumbing installation. Place the
gasket and washer over the threads of the dispenser base.
Hand tighten the dispenser nut until the dispenser, gasket
and washer are secured to the sink basin or countertop. The
dispenser should not be easily moved or twisted once
secured. Install Danger: Scald Warning label on the
backplash adjacent to the dispenser.
CAUTION
This dispenser does NOT deliver cold water.
The dispenser only delivers near boiling hot water
that can range from 140°F – 212°F (60°C – 100°C).
Dispenser
Bottom of
sink basin /
countertop
Proprietary hot
water line
Figure 3
Dispenser
nut
Figure 4
Washer
Gasket
Summary of Contents for HotMAx HM013240
Page 16: ...16 NOTES EX07200 82 Rev C ...
