HD491 Smart Encoder
Copyright © 2000-2014 EEG Enterprises, Inc. 12
All Rights Reserved.
Web Configuration
The Web Configuration interface enables you to access configurations
and log files for your 491 applications from any computer on your local
network. Several web applications are installed at the factory for all
HD491 encoders: a Startup Setting editor, a web-based serial-emulation
Terminal for entering Smart Encoder commands, a documentation
library, and the iCap™ application.
To use Web Configuration, first connect the Ethernet connector on the
rear panel of the HD491 to your local network. Then, use the front panel
LCD and button pad to give the encoder a valid IP address and subnet
mask for your network by navigating to
System Setup | Network Setup
| IP Address
and
System Setup | Network Setup | Subnet Mask.
Once you have set up the front panel IP settings, you can leave your
encoder and open up a web browser on any PC on the same local
network. Navigate to the IP address that you configured on the
encoder’s front panel; for example, type
192.168.1.15
into the address
bar of the browser if that is the address you entered into the front panel.
If you cannot navigate to the page in your web browser, check with
your network administrator that the IP Address and Subnet Mask you
entered on the encoder front panel are valid parameters for your
network, since individual settings vary.
