STEP 2
Attaching the legs
The legs and top of your cart model may be numbered. (fig 2.1) Match the correct leg
to the appropriate position. If the legs are not numbered on your cart model then they
can be attached at any corner HOWEVER take note below.
Each leg has a hole punched near the floor end. (fig 2.2) This hole must face the
opposing leg on the opposite end toward the center as shown. (fig 2.3) This is the hole
where the shelf will mount.
SPECIAL WARNING for model 703 cart with insert boards: on the 703 model you will
only install the 2 OUTSIDE screws on the leg nearest the lowest of the 3 accessory
board cut-outs. (fig 2.5 and 2.6) Failure to follow this instruction may cause damage to
the accessory board. The 2 screws, along with the shelf mounting screw, will hold the
leg securely.
Each leg will attach with 4 screws. (fig 2.4) Be careful not to over-tighten and possibly
strip-out the mounting holes. It is best to drive the screws in most of the way with the
power driver and hand tighten the last few turns. It may be easiest to start all 4
screws on each leg first and then tighten them as a set.
Repeat the process for the remaining 3 legs (noting the shelf mounting hole on each
one).
2.1 if numbered, numbers should
match
2.2 shelf mount hole (metal carts
similar)
2.3 shelf hole location
2.4 driving screws
2.5 screws will penetrate the opening
2.6 correct - only 2 screws
STEP 3
Attaching the Handle
(This step is only applicable on models 701, 703, 713, and 715)
Attach the tubular handle at the location of the 4 handle holes with the remaining 4
large screws as provided.
* * IMPORTANT * *
Holes must face each other end to
end and be to the inside of cart