© Edwards Limited 2007. All rights reserved.
Page 21
Edwards and the Edwards logo are trademarks of Edwards Limited.
Ser
ial
In
te
rfa
ce
Op
er
at
io
n
D374-20-880 Issue E
140
Parallel (tool) interface output status
Refer to
151
*
Auxiliary interface
-
160
Auxiliary interface input status
Refer to
169
Auxiliary interface output status
Refer to
172
Inverter current
0.1A
173
Inverter power
0.1kW
174
Inverter speed
0.1Hz
175
Inverter torque
0.005%
176
Inverter status
-
245
GRC status
-
*
These parameters can only be specified in ?I query messages.
†
Information on these parameters is in the form {status level}: Refer to
.
‡
0 (oil level or water flow low) or 1 (oil level or water flow acceptable).
Table 10 - Priority Level
Value
Meaning
0
Indication only; no warning or alarm.
1
Warning condition exists.
2
Alarm condition exists: shut down the pump unless run til crash is set.
3
Alarm condition exists: shut down the pump.
Table 11 - Bitfield status
Value
Meaning
0
Module missing
1
Sensor present at switch-on, but now disconnected
2
Wrong gas module fitted
3
Voltage above valid maximum voltage
4
Voltage below valid minimum voltage
5
ADC (analogue to digital convertor) not operating
6
Electrical supply has been interrupted
7
Watchdog reset has occurred
8
Sensor missing at switch on
9
Module switching on
10
No current consumption at pump switch-on
11
Wrong phase input to pump
12
EMS (emergency stop) has been activated
13
Flow sensor zero out of range
14
Cannot zero sensors
15
Configuration set read error
Table 9 - Parameters
{parameter}
Description
Measurement Unit
