Edwards & Co PA0100, Instruction Manual, Page: 7 / 14

Assembling the base
This section shows how to assemble the base when opened from the
box.
Tools required - small “Phillips” screwdriver
Put the tubes on the stabiliser guards into the
socket.
Press the tube down firmly until they reach
the bottom of the socket.
Using a Phillips screwdriver, fasten the
included screws into the stabiliser tubing.
When using the ISOFIX installation system,
extend the fixing lock by lifting the latch and
turning the lock in the direction of the arrow.
Using the ISOFIX arms
The fixing locks can be stowed when not in
use.
IMPORTANT - always stow the ISOFIX fixing
lock as pictured in Figure (3) if installing your
base using the 3-point seat belt method.
7
1
2
3