Assembly Instructions : Muscle Rack 6600 Series Storage Cabinet Page 4
Assembly Instructions : Muscle Rack 6600 Series Storage Cabinet Page 4
Assembly Instructions : Muscle Rack 6600 Series Storage Cabinet Page 4
Step 5 - Door Assembly
First the unit needs to be squared. Turn the unit upright
and place on a level floor. Loosen and re-tighten the
screws appropriately to ensure the unit is square. Now
the doors are ready to be hung. With the hinge pins
pointed down, select the door with three (3) holes for the
handle cutout (see figure 5 for assistance). This is the
right hand door. Take the right hand door and align the
door’s hinge pins with the companion hinges located on
the right side panel. Some of the hinge pins may have
moved or come out of alignment during shipping and
handling. If so, move the hinge pins back to the proper
position so that they align with the companion hinge
holes. Slowly slide the hinge pins into the holes to prop-
erly seat the door. Repeat the same process for the left
hand door.
Figure 5 - Door Assembly
Step 6 - Shelf Assembly
The unit is now ready for the shelves. Holding the shelf,
notice there are square and round cutouts on the edge of
the part. The square cutouts will install to the back of the
unit, and the round to the front. First select a level for
the shelf by selecting a set of square notches located
inside the unit on the back left and back right sides. A
series of round holes are located on the inside of the left
and right hand side panels near the hinges. Using a
shelf clip, insert the upper notch into a round hole oppo-
site the selected square holes where the shelf is to be
located. Push and “snap” the lower notch of the clip into
place using the next lowest round hole. Repeat the shelf
clip installation on the opposite corresponding side. To
insert the shelf, place the end with the square cutout to
the rear of the unit. Angle the shelf so that the shelf will
engage the square notches on the back and lower onto
the front shelf clips. Repeat the process for all remaining
shelves.
Figure 6 - Shelf Assembly
Step 7 - Final Assembly
To complete the unit, the locking handle needs to be in-
stalled on the right hand door. Follow carefully the as-
sembly instructions as written on the handle hardware
bag. Helpful hints on installation: The door rods will
slide into small plastic guides on the door. Install the
handle to the right hand door, then place the cam in posi-
tion. Slide the tip of the door rod into the lower plastic
guide and position the door rod onto the pin located on
the cam and hold it in place. Install the other door rod in
the upper plastic guide and position onto pin located on
the cam. Install the remaining hardware.
Figure 7 - Final Assembly
