Take two (2) 24” braces with the
shelf ledge facing up
,
and one (1) short 36” post and attach rivets from the
brace to the top two (2) holes of the short post. Take
one (1) long 60” post and attach the opposite end of the
brace to the holes of the long post so the
brace is
level,
tap the brace down to seat. Attach the bottom
brace to the short 36” post using the bottom holes, and
the opposite end to the long 60” post, tap the brace
down to seat. Take one (1) drawer mount and attach
the rivets to the short and long post holes located just
below the 24” braces, and tap down drawer mount to
seat. take one (1) drawer slide and insert it into the
slide of the drawer mount. Repeat this step for the op-
posite end assembly.
Assembly Instructions for MRWB52COS
Assembly Instructions for MRWB52COS
Assembly Instructions for MRWB52COS
Add the top wood shelf to the top shelf beam, the drawer
wood shelves to the drawer assemblies, the bottom wood
shelf to the bottom assembly, and the work surface top to
the work surface assembly. Finish the assembly of the
workbench by installing the light fixture to the underside of
the top wood shelf. Install using the hardware and instruc-
tions that are provided with the light fixture.
Step
1
Step
3
Step
4
Post are directional.
The slot must point
down.
Drawer Mount
Drawer Slide
Long Post
Short Post
24” Brace
Shelf Ledge Up
Tap Lightly
26” Drawer Shelf Braces
(Bend facing down & the same
for back of drawer slides also)
Peg Board
Take four (4) 60” beams with the
bend facing up
, and attach
the rivets even with the braces from the two end assembly's,
and tap down to seat. Install the top shelf beam and one (1)
60” beam with the
bend facing down
, to the top holes of the
back posts. Next install a peg board bracket to the beam of
the top assembly using the nuts and bolts provided. Assem-
ble the center drawer assembly by taking a peg board bracket,
one (1) shelf support, and one (1) center mounting bracket
and bolt them to the work surface back beam (see figure A).
Next bolt the shelf support bracket, and the last center mount-
ing bracket to the opposite beam. Attach the two (2) center
drawer mounts by placing the rivets into the holes of the cen-
ter mounting brackets. Insert the drawer slides into the center
drawer mount slides. Add the final shelf support to the bot-
tom two (2) beams using the nuts and bolts provided.
Step
2
Center Drawer Mount
Peg Board Brackets
Figure A
Shelf Support
Top Shelf Beam
60” Beams
Peg Board Bracket
Shelf Support
Center
Mounting
Bracket
Drawer Slides
Place the peg board to the inside of the back post of the work
bench. Using the first hole from the top of the back post,
align the holes of the peg board to the holes on the back
post, and fasten using the nuts and bolts provided. Align the
holes on the peg board brackets to the holes of the peg
board, and fasten the peg board to the peg board brackets
using the nuts and bolts provided. Take the four (4) 26”
drawer shelf braces and with the
shelf ledge facing down
,
insert the two (2) rivets into the two (2) holes located on the
front of the drawer slides.
60” Beam
(Bend facing down)
Light fixture installs
to the underside of
the top wood shelf.
Top Wood Shelf
Bottom Wood Shelf
Work
Surface
Top
Drawer
Wood
Shelves
