REF.
33973
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
9
FAN OPERATION
- Place the fan on a flat and dry surface.
- Before connecting the device to the network, make sure that the switch is in the "0" position.
- Plug the power cord into the 220 / 240V - 50Hz AC outlet.
- With the 3-speed system you can turn on the fan. This system is designed to give you the maximum flexibility. You can
also activate the oscillation function using the oscillation switch.
POSITION 0: position at OFF
POSITION 1: first speed
POSITION 2: second speed
POSITION 3: third speed
OSCILLATION: oscillation button /fixed position
- If you do not use the fan for a long time, unplug the cord from the electrical outlet.
- Never try to disassemble the device from the engine.
- If you notice any anomaly (such as unusual fan noise), turn off the device and unplug it immediately.
- Make sure that no objects or liquids enter the inside of the fan through the openings in your box.
- The fan should only be used in dry environments.
- Protect the device from dust, moisture, sunlight and direct heat.
CLEANING AND MAINTENANCE
-Make sure that the appliance is switched off before cleaning it.
- Clean with a soft damp cloth, without detergent, aggressive liquids or solvents.
- Do not immerse the fan in water or any other liquid.
- If the fan is not going to be used for a long period of time, clean and protect it and keep it in a dry place.
FEATURES
- Power: 60W
- Speed: 3 niveles
- Fixed or oscillating position
- Security grille
- Diameter of the blades: 40cm
- Heights: min.100 - max.120cm
PARTS OF THE FAN
1. Screw fixing the base
2. Washer for the fixing screw of the base
3. Separator
4. Base
5. Support tube
6. Joint screw
7. Adjusting screw
8. Fixing nut
9. Fixing nut
10. Control switch
11. Oscillation control
12. Motor
13. Motor shaft
14. Rear protection grille
15. Four screws of the rear protection grid
16. Helix
17. Fixing screw to fix the propeller to the motor shaft
18. Front protection grille
19. Screw and nut to join the front grille to the rear grille
20. Grid fixing clips
ASSEMBLY INSTRUCTIONS FOR THE BASE AND THE BODY
1. Remove all packaging carefully, avoid scratching the plastic covers with scissors or knives.
3. Insert the rear grille into the front of the motor shaft. Make sure the center holes are tight on the shaft.
4. Secure the rear grille using the 4 screws.
5. Insert the propeller
6. Fix the helix with the screw
7. Cover the front grille, adjusting it to the lace
8. Tighten the security screw with a screwdriver
9. Assemble the base as shown in the diagram above, fixing it with the screw below the base.
