- 7 -
unit still does not starts in 10 minutes, please contact your local
distributor service station for repair.
8. When the dehumidifier is in operation, the running compressor will
produce heat and make the room temperature higher. This is normal
condition.
DRAINAGE INSTRUCTION
The extracted water can be collected by water tank, or drained
continuously with a PVC hose (not available):
USE OF WATER TANK
When the water full indicator illuminates, the tank is
full, and the compressor and the fan will stop
operation, please empty the water tank:
1. Remove the water tank as Fig 01. and empty it.
2. Insert gently the water tank into the unit reach to
its original position.
CONTINUOUS DRAINAGE
1. When you want to use this function, please
Pull out the water tank, and plug the discharge
water pipe in “Water out hole” (See Fig.02).
replace the water tank into the unit, then you can
operate the unit.
Fig 01
Fig 02
- 8 -
FILTER REMOVAL
•
The filter can be removed from its slot
by gripping the filter handle and sliding
it out from the back of the appliance.
• Every 2 weeks, remove the filter and
clean it with warm water, below 40°C.
Allow it to dry naturally and then
replace.
MAINTENANCE INSTRUCTION
1. The unit is not allow to be located on the floor of soft and uneven
surface when the unit is in operation to avoid occurrence of vibration and
noise.
2. Never insert any slim rod and hard object into the unit body to avoid
occurrence of hazard or unit failure.
3. During power off or when not in use for a long time, please pull out
the power cord from the outlet.
4. For a better dehumidifying effect, the areas in front and rear of the
unit should be clear and free from obstacles, which will block the air flow
for the unit.
