Edirol PCR-A30, Owner'S Manual

Page: 67 / 112

67
Using the PCR-A30 as a MIDI controller
For Basic mode or Advanced mode 1
fig.f0
The display will blink “F0”, which is the first byte (starting status byte) of a
system exclusive message. (This cannot be changed.)
7.
Confirm what’s indicated, and press the [ENTER] button.
8.
Use the [0] – [F] keys to input the second byte.
9.
Press the [ENTER] button.
10.
Input the third and subsequent bytes in the same way.
11.
When you have finished inputting the message, use the keyboard to enter [F] and [7], specifying
the ending status byte “F7”.
12.
Press the [ENTER] button.
13.
If Advanced mode1, specify the range of values. (
➔
“Specifying the range of values (upper and
lower limits)” (p. 58))
14.
Specify the output port. (
➔
“Specifying the port” (p. 54))
15.
If you are making an assignment for a button, specify the button mode. (
➔
“Specifying the
button mode” (p. 54))
For Advanced mode 2
fig.f-
The display will indicate “F-.”
7.
Use the [6] , [8] , [A] – [C] , [F] keys to specify the system message.
8.
Press the [ENTER] button.
9.
Specify the output port. (
➔
“Specifying the port” (p. 54))
For Advanced modes 3 or 4
fig.l--
The display will indicate “L–”.
7.
Use the [0] – [F] keys of the keyboard to specify the number (decimal) of
bytes you want to input.
8.
Press the [ENTER] button.
9.
Use the [0] – [F] keys to input the first byte.
10.
Press the [ENTER] button.
11.
Input the second and subsequent bytes in the same way.
12.
After you have input the number of bytes you specified in step 7, the PCR-A30 will check whether
the messages you’ve input are indeed valid MIDI messages. If there is a problem, the display will
indicate “ERR”.
In this case, you should press the
[ENTER] button, which takes you back to step 7, where you
can input the values over again.
13.
If Advanced mode4, specify the range of values. (
➔
“Specifying the range of values (upper and
lower limits)” (p. 58))
14.
Specify the output port. (
➔
“Specifying the port” (p. 54))
15.
If you are making an assignment for a button, specify the button mode. (
➔
“Specifying the
button mode” (p. 54))
*1 Reference
Specifying the Sys Ex. ASSIGN
• “Specifying the checksum” (p. 68)
• “Specifying the location of the data” (p. 69)
• “Inputting channel/block data” (p. 69)
Some examples of inputting various actual system exclusive messages.
• “GM2 System On” (p. 70)
• “Master Volume” (p. 71)
• “Bend Pitch Control” (p. 72)
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.
PCR-A30_e2.book 67 ページ ２００３年１０月２２日 水曜日 午後３時１９分