Edirol PCR-A30, Owner'S Manual

Page: 66 / 112

66
Using the PCR-A30 as a MIDI controller
■
Sys Ex. ASSIGN
Here’s how you can assign a system exclusive message to a controller. Advanced mode 2 lets you
assign a single-byte system message (System realtime message, tune request).
Advanced modes 3 and 4 let you assign any desired message. (Input up to 24 bytes)
Sys Ex. ASSIGN can calculate the checksum automatically, and lets you specify a variable (data)
range or embed a channel/block number within the message. (
“Sys Ex. ASSIGN items” (p. 68))
In Sys Ex. ASSIGN, the input mode will be HEX mode.
fig.edt
1
Press the [EDIT] button.
The display will indicate “EDT”.
fig.r-1
2
Slightly move the controller to which you want to assign the system
exclusive message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3
Confirm what’s indicated, and press the [ENTER] button.
fig.se0
4
Press the [SYSTEM Ex.] key.
5
If you want to select an Advanced mode, press a key from [1] to [4] .
The selected mode will blink in the display.
6
Confirm what’s indicated, and press the [ENTER] button.
* Then continue with the procedure described in Basic mode or Advanced mode (p. 67).
For some actual examples of settings, refer to “Examples of assigning system exclusive
messages” (p. 70).
Mode num-
ber
Key-
board
Mode Value range Required ending Notes/restrictions
Basic mode 0 Sys Ex. message Default range Input F7 1st byte fixed at F0
Advanced
mode 1
1 Sys Ex. message Assignable Input F7 1st byte fixed at F0
Advanced
mode 2
2
Single byte system
message
– –
[0–5, 7, 9, D, E] [DATA]
[CHECKSUM]
buttons
are invalid
Advanced
mode 3
3
Any desired MIDI
message
Default range
Specified number of
bytes [CHECKSUM] button is
invalid
Advanced
mode 4
4
Any desired MIDI
message
Assignable
Specified number of
bytes [CHECKSUM] button is
invalid
PCR-A30_e2.book 66 ページ ２００３年１０月２２日 水曜日 午後３時１９分