2
Transmitter and receiver channel syncronization
When synchronizing the units should not be more than one meter apart.
• Press mute/sync button on transmitterr before it is turned on.
• Turn the transmitter on and purple LED flashes to indicate the activation of channel-
sync mode.
• Turn receiver(s) on to be channel synchronized (one or multiple receivers can be
turned on at the same time).
• When channel is successfully synchronized, receiver’s LCD shows same channel as that
of the transmitter and its LED turns steady blue.
• Press the transmitter’s mute/sync button to exit sync setup. When the transmitter has
left sync set up, the sound is turned off when the mute/sync button is pressed.
Note! If synchronization fails
1. Turn the transmitter off and repete above procedure to redo the synchronization.
2. If it still doesn’t work, turn off the transmitter and receiver(s) and redo the
synchronzation procedure again as described above.
Receiver
1. Antenna
2. Power/Signal indikator
3. LCD battery status
4. LCD channel lock
5. LCD selected channel
6. Volume
7. Up/Down button
8. Power button
9. Earphone socket
Power on/off
• Press and hold power button
for 1 second to turn the receiver on.
LCD screen shows and then last used channel.
• Press and hold power button
for 2 seconds to turn the receiver off.
LCD screen shows
and then shuts down and the LCD turns black.
Power saving (receiver only)
Power of receivers will be off if no signal is received for 20 minutes.