3. Pairing/connecting
1) Pairing headset with Bluetooth cell phone via Bluetooth
Prior to using the headset for the first time, you have to pair it with a
Bluetooth-enabled cell phone. The pairing procedures are subject to
different models of cell phones. Please refer to your cell phone user’s
manual for further information.
The general pairing procedures are as follows:
1)
Keep your headset turned off and within 1 meter of phone ,the nearer the
better ;
2)
Press and hold
about 5 seconds until the red and blue LED flash
alternately, the headset enter into paring mode and emits “pairing”
3)
Activate your cell phone’s Bluetooth function and search for Bluetooth
devices within range, select “W290BT” from the list of devices shown
(enter password “0000 ” if the headset prompt). After successful
connecting, blue LED of headset flashes twice every 4 seconds and emits
“connected”
Remarks:
Pairing mode will last 2 minutes, the headset will back to standby mode
if the pairing failure after 2 minutes later.
The headset will connect to the last connected device automatically when
turned on.
When the headset is in standby mode and not connect with device, short
press any button of headset, it will try to connect to last connected
device.
When the headset is out of effective range and not connected with device,
it will automatically connected after back to effective arrange in 5
minutes. If overtime, short press any button, it will connected again.
2) Pairing the headset with a Bluetooth transmitter via Bluetooth
You can connect the headset to a Bluetooth transmitter to enjoy music
wirelessly. Hereby take BTT005 (Bluetooth transmitter, not included in
accessories) for example. The pairing steps are as follows:
