11
Installing the Door Handle
To install the door handle:
1. Open the door and carefully pull the door gasket around the area where the handle is to
be installed.
2. Carefully remove the two pre-installed decorative plugs from the front of the door.
3. Insert each Phillips head screw through the gasket side of the door until the screw
passes through the door.
4. Align the handle with the screws and tighten using a Phillips head screwdriver until the
handle is flush against the door frame.
5. Carefully press the door gasket into its original position.
Note:
Some wine refrigerators do not have decorative plugs installed.
Warning:
Do not over-tighten the screws as this may cause damage to the handle or the
stainless steel door.
!
Installing the Shelves
To prevent damaging the door gasket, make sure to open the door fully before pulling the
shelves off their tracks.
1. Open the door completely.
2. Slide the shelf onto the shelf track and slowly push it back until it stops.
3. Push down on the front of the shelf to allow the back of the shelf to lift over the plastic
post. (Imagine a seesaw movement.) Continue to push the shelf back until both
notches pass through the plastic posts on each side of the shelf track.
4. Continue to push the shelf back into place.
Removing the Shelves
1. Open the door completely.
2. Make sure the shelf is pushed in completely towards the back of the refrigerator.
3. If necessary, make sure you remove all the contents sitting on the shelf.
4. Pull the shelf forward until the notch aligns with the plastic post on each side of the
shelf track.
5. Lift the shelf until both notches pass through the posts
6. Pull the shelf straight out until it is completely removed. Set aside gently.