EdgeStar Built-in Beverage Cooler
8
OPERATION
Installation Check List before Operation
1. Have all packing materials and tape been removed from the interior and
exterior of the beverage cooler?
2. Have the installation instructions been followed, including connecting the
machine to electricity? And has proper grounding been installed for the beverage
cooler?
3. Has the machine been leveled?
4. Is the beverage cooler in a site where the ambient temperature is between 50º
F and 95º F all year round?
5
. Is there a clearance of at least 2/5” at the rear, 1/5” at the top and 1/5” at the
sides for proper air circulation?
Using the Temperature Control Panel
RUN
C
F
Use the up and down buttons to adjust the temperature. The temperature
displayed can be in Fahrenheit or Celsius. This beverage cooler has a
temperature range from 38°F to 50°F.
This beverage cooler has two displays, a Set Display that shows the set
temperature, and a Current Temperature Display that shows the current
temperature. Note: It is normal to see the set temperature and current
temperature displays being a few degrees off from each other.
Press the button on the control panel to lower the temperature by 1
degree increments.
Allow at least 24 hours before storing your beverages and to allow the
temperature to acclimate.
Press the button on the control panel to increase the temperature by 1
degree increments.
Press the
button to turn the inner light on or off.
Press and hold the power button for approximately 3 seconds to turn the
unit’s power on or off. The Run Light will illuminate when the unit is
working.
The Celsius or Fahrenheit light will be lit depending on what scale
temperature is being displayed. To switch between C and F, press and
hold the and buttons at the same time for approximately 5 seconds
until the temperature scale changes.
Note: Whether your
beverage cooler can reach
the actual set temperature
depends on the ambient
environmental conditions.
Run Light
Temp. Buttons
Light Button
Power Button
Current Temperature
Set Display
Celsius and Fahrenheit
Lights
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
